This plugin is dependent on the magnificent TimberAPI. You can install this plugin manually by cloning the repo, building itĪnd adding the dll to your bepinex plugins folder. Recommended way to install this mod is through Thunderstore. This plugin might cause some lag spikes when a drought ends or starts.Though if you have a line of Floodgate that are synchronized, you only need to enable the trigger for one of them, as the built in synchronization will take care of.The trigger settings are NOT synchronized to neighboring Floodgates.However, there is no limit with how many Floodgates can be connected to a certain StreamGauge. The main difference is that instead of height, you can choose when to pause/resume the pumps.Ĭurretly you can only link a single Stream Gauge with a Floodgate or water pump. Normal and mechanical water pumps and wter dumps have similar setting compared to floodgates. Of triggering once when the thresholds are crossed. IMPORTANT! Be aware that if a Stream Gauge is linked, then the Floodgate's height will be set always when below low or above high threshold, instead High threshold height: The height to set when the water depth is above the chosen high threshold.High threshold: Set the floodgate height when water depth is above this value.Low threshold height: The height to set when the water depth is below the chosen low threshold.Low threshold: Set the floodgate height when water depth is below this value.This allows you to control the Floodgate based on the water depth On the Advanced you can link a Floodgate with a Stream Gauge. Once the schedule has been running in peace for a while. If you change the timestamp, then the height might get instantly changed. Normally the height is set at the selected timestamp.Optionally disable schedule during droughts.Enable Schedule based setting of height.The basic tab also contains the settings for automating floodgates based on a schedule. Enable setting of height when drought starts.Enable setting of height when drought ends.The fist settings on the Basic tab are related to Droughts. Be careful, or you'll end up drying/flooding everything! Floodgate Drought ![]() ![]() Example images below.īear in mind that it is possible to create some very janky setups with enabling multiple triggers on the same floodgates. The will add a simple UI fragment on the Floodgate UI. The current version v2.0.2 only works with experimental v0.2.6. When a Drought starts or ends, based on a basic schedule or based on a Stream Gauge depth. Currently we offer automatic setting of floodgate height This plugin for Timberborn allows you to automate your Floodgates a little.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |